Linux bridging VLANs

Hi

I hope you can help.

Can a linux box with 3 interfaces be configured as follows:

Interface 1 marks traffic entering it as 802.1q vlan 100 and has no ip address
Interface 2 marks traffic entering it as 802.1q vlan 200 as has no ip address
Interface 3 is a 802.1q trunk and uplinks vlan 100 and 200, again it has no ip address

All 3 interfaces are then added to a linux bridge, basically mimicking a switch.

I am trying to figure out if I can test the tagging on the XS708E (see other post)...

Linux bridging VLANs